Change Screen Layout; Answering Site Questions; Answering Id Questions - LANDTEC GEM5000 Operating Manual

Gas analyzer

Hide thumbs Also See for GEM5000:

Table of Contents

OMGEM5KN4.7.1

8.2 Change screen layout

Use key 2 to toggle between 2 different ways of viewing the gas reading screen:

You can use key 4 and key 6 to switch between the gases page and the pressure & flow

page. This feature is only available on analyzers running on firmware version 1.11 or later.

Prior to taking the readings at a particular site, the site questions should be populated, this

is only necessary when using site questions, if not, please proceed with the reading as

normal. This is accessed via the 'Special Action' menu. The answers to these questions

are then stored and appended to each reading stored thereafter, until the site questions

are updated for another site. You will need LSGAM software to create site questions and if

you are using LSGAM, this data will be uploaded to LSGAM along with the reading data.

Prior to, or after, you have taken the reading, the ID questions should be populated, this is

only necessary when using ID questions, if not, please proceed with the reading as

normal. When you have uploaded IDs with ID questions assigned to them (LSGAM

software required), you will be prompted to answer these questions at the end of the

reading, this means that the answer only equates to that reading.

Page 40 of 70

GEM5000 Gas Analyzer

Default view

Table of Contents