Chapter 9 Ipv6 Route-Map Policy Configuration; Ipv6 Routing Policy Configuration; Configuring The Ipv6 Routing Policy - Zte ZXR10 ZSR V2 Configuration Manual

Chapter 9
IPv6 Route-Map Policy
Configuration
The IPv6 Router-Map provides IPv6 on the basis of the IPv4 Router-Map. For a brief
description of the Router-Map, see the "Router-Map Overview" section in the ZXR10 ZSR
V2 (V2.00.10) Configuration Guide (Policy Template).
Table of Contents

IPv6 Routing Policy Configuration ..............................................................................9-1

IPv6 Policy Route Configuration ...............................................................................9-30
9.1 IPv6 Routing Policy Configuration
IPv6 has the same routing policy as IPv4. For the detailed concepts and principles, refer
to the "Routing Policy Overview" section in the ZXR10 ZSR V2 (V2.00.10) Configuration
Guide (Policy Template).

9.1.1 Configuring the IPv6 Routing Policy

This procedure describes how to configure the IPv6 routing policy, including basic
attributes, route attributes, and how the policy is invoked in a routing protocol.
Steps
1. In route-map configuration mode, configure the basic attributes of the IPv6 routing
policy.
Step
1
SJ-20140504150128-018|2014-05-10 (R1.0)
Command
route-map <route-map-name>[permit |
ZXR10(config)#
deny][<sequence-number>
9-1
ZTE Proprietary and Confidential
Description
Creates a route map for policy
routing, and enters route-map
configuration mode.