Policy-Map; Priority - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example

policy-map

Use this command to set policy map and enter policy map con-
figuration mode. Delete the policy map with the no form of this
command.
Global configuration
policy-map <policy-map-name>
no policy-map <policy-map-name>
<policy-map-name>
� The policy mapping which has already applied on the interface
must not be deleted.
� When the policy mapping is deleted, all policies will be deleted
at the same time.
� This command is applied to ZXR10 GER and ZXR 10
T64E/T128.
This example describes how to set a policy mapping named pol-
icy_1 and enter policy mapping configuration mode.
ZXR10(config)#policy-map policy_1
ZXR10(config-pmap)#
service-policy
show policy-map

priority

Use this command to configure the port default priority. Restore
the default configuration with the no form of this command.
Policy class configuration
priority <bandwidth><burst>
no priority
<bandwidth>
<burst>
� This command can not be used at policy configuration mode
with the bandwidth command.
� Default policy can not use this command.
� This command is applied to ZXR10 GER.
This example describes how to set precedence for class_1 policy
class of policy_1, set maximal bandwidth as 128kbps and burst
size as 200000 bit.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 QoS configuration(Router Series)
Defines policy mapping name
Maximum bandwidth, unit: kbps, range:
8~2000000
Burst size, in bits, range: 256~16000000
53