Configuring A Dhcpv6 Relay - Zte ZXR10 ZSR V2 Configuration Manual

7. Verify the configurations.
Command
ZXR10#
<interface-name>]|[summary]
8. Maintain DHCPv6.
Command
ZXR10#
ZXR10#
<interface-name>]|[prefix<IPv6 prefix>[vrf-instance
<vrf-name>]]|[address <IPv6 address>[vrf-instance
<vrf-name>]]
– End of Steps –

24.3 Configuring a DHCPv6 Relay

This procedure describes how to configure a DHCPv6 relay.
Steps
1. Enable the DHCPv6 function.
Step
1
2
2. Configure a DHCPv6 relay server group.
Step
1
2
SJ-20140504150128-018|2014-05-10 (R1.0)
show ipv6 dhcp server user [interface
debug dhcpv6 server
kick-off ipv6 dhcp server user [[interface
Command
dhcp ipv6
ZXR10(config)#
ZXR10(config-dhcpv6)#
Command
ZXR10(config-dhcpv6)#
ZXR10(config-dhcpv6r-server-group)#
{normal | first | round-robin}
Function
Enables DHCPv6 server debugging
function.
Kicks off online users of the DHCP
server by the specified attribute, such as
interface, IPv6 prefix and IPv6 address.
enable
relay server group <number>
algorithm
24-7
Chapter 24 DHCPv6 Configuration
Function
Shows the client information on a
DHCPv6 server.
Function
Enters DHCPv6 configuration
mode.
Enables the embedded
DHCPv6 function.
Function
Enters DHCPv6 relay server
group configuration mode
from DHCPv6 configuration
mode.
Configures the DHCPv6 relay
server to use a policy. The
default forwarding mode is
normal.
ZTE Proprietary and Confidential