Zte ZXR10 ZSR V2 Configuration Manual page 62

ZXR10 ZSR V2 Configuration Guide (IPv6)
<map-tag>: specifies the route map used for protocol route redistribution.
4. Enable the RIPng protocol function for an interface.
Step
1
2
5. Configure the optional parameters under the RIPng interface.
Command
ZXR10(config-ripng-if-interface-name)#
split-horizon
ZXR10(config-ripng-if-interface-name)#
poison-reverse
ZXR10(config-ripng-if-interface-name)#
interface active
ZXR10(config-ripng-if-interface-name)#
interface passive
ZXR10(config-ripng-if-interface-name)#
neighbor <X:X::X:X>
ZXR10(config-ripng-if-interface-name)#
originate-default-route [only]
6. Verify the configurations.
SJ-20140504150128-018|2014-05-10 (R1.0)
Command
interface <interface-name>
ZXR10(config-ripng)#
ZXR10(config-ripng-if-interface-name)#
enable
ipv6 rip
ipv6 rip
ipv6 rip
ipv6 rip
ipv6 rip
ipv6 rip
ipv6 rip
5-4
ZTE Proprietary and Confidential
Function
Enters RIPng interface
configuration mode.
Enables RIPng on an
interface.
Function
Enables split horizon on the
interface, default: Enable.
Enables poison reverse on the
interface, default: Enable.
Configures the active interface
so that the interface only sends
packets but does not receive
packets.
To cancel the configuration and
restore normal packet sending
and receiving, run the no form of
the command.
Configures the passive interface
so that the interface only
receives packets but does not
send packets.
To cancel the configuration and
restore normal packet sending
and receiving, run the no form of
the command.
Configures the neighbor address
of the RIPng so that unicast
packets are sent to this neighbor
only.
Originates the default route of
the RIPng on the interface.