Figure 13-1 Network Architecture Of Pim-Dm Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual

Chapter 13 IPv6 PIM-DM Configuration

Figure 13-1 Network Architecture of PIM-DM Configuration Example

Configuration Flow
1. Configure addresses of related interfaces.
2. Enters the multicast mode.
3. Enters the IPv6 PIM mode.
4. Enable the PIM-DM function for corresponding interfaces.
Configuration Commands
Run the following commands on R1:
R1(config)#interface gei-0/9
R1(config-if-gei-0/9)#ipv6 enable
R1(config-if-gei-0/9)#ipv6 address 199::1/64
R1(config-if-gei-0/9)#no shutdown
R1(config-if-gei-0/9)#exit
R1(config)#interface gei-0/7
R1(config-if-gei-0/7)#ipv6 enable
R1(config-if-gei-0/7)#ipv6 address 198::1/64
R1(config-if-gei-0/7)#no shutdown
R1(config-if-gei-0/7)#exit
R1(config)#ipv6 multicast-routing
R1(config-mcast-ipv6)#router pim
R1(config-mcast-ipv6-pim)#interface gei-0/9
R1(config-mcast-ipv6-pim-if-gei-0/9)#pimdm
R1(config-mcast-ipv6-pim-if-gei-0/9)#exit
R1(config-mcast-ipv6-pim)#interface gei-0/7
R1(config-mcast-ipv6-pim-if-gei-0/7)#pimdm
R1(config-mcast-ipv6-pim-if-gei-0/7)#end
Run the following commands on R2:
R2(config)#interface gei-0/4
R2(config-if-gei-0/4)#ipv6 enable
R2(config-if-gei-0/4)#ipv6 address 199::2/64
13-3
SJ-20140504150128-018|2014-05-10 (R1.0) ZTE Proprietary and Confidential