Zte ZXR10 ZSR V2 Configuration Manual page 88

ZXR10 ZSR V2 Configuration Guide (IPv6)
11.11.11.11
R2#show ipv6 forwarding route 3555::52
IPv6 Routing Table:
Headers: Dest: Destination, Gw: Gateway, Pri: Priority;
Codes : K: kernel, I1: isis-l1, SFN: sf-nat64, R: ripng, AF: aftr, B: bgp,
Dest
Interface
3555::/64
gei-1/3
R2#ping6 3555::52
sending 5,100-byte ICMP echo(es) to 3555:0:0:0:0:0:0:52,timeout is 2 second(s).
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 2/2/3 ms.
Check and verify the configuration result on R3, as shown below.
R3#show running-config ospfv3
! <OSPFV3>
ipv6 router ospf 1
router-id 1.1.1.5
interface gei-3/6 area 0.0.0.10 instance 0
$
interface loopback5 area 0.0.0.10 instance 0
$
!
! </OSPFV3>
R3#show ipv6 ospf neighbor
OSPFv3 Process 1
Neighbor ID
10.10.10.10
R3#show ipv6 forwarding route 3555::52
IPv6 Routing Table:
Headers: Dest: Destination, Gw: Gateway, Pri: Priority;
Codes : K: kernel, I1: isis-l1, SFN: sf-nat64, R: ripng, AF: aftr, B: bgp,
Dest
Interface
3555::/64
gei-3/6
SJ-20140504150128-018|2014-05-10 (R1.0)
1 FULL/DR
D: direct, I2: isis-l2, SLN: sl-nat64, O: ospfv3, D6: dhcp, P: ppp,
S: static, N: nd, V: vrrp, A: address, M: multicast, UI: user-ipaddr;
Pri Gw
110 fe80:2e::2d0:d0ff:fe78:99dd
Pri State
1 FULL/DR
D: direct, I2: isis-l2, SLN: sl-nat64, O: ospfv3, D6: dhcp, P: ppp,
S: static, N: nd, V: vrrp, A: address, M: multicast, UI: user-ipaddr;
Pri Gw
110 fe80:36::2d0:d0ff:feaf:cc10
00:00:37 18
Owner
O
Dead Time Interface ID
00:00:31 45
Owner
O
6-18
gei-1/3
Metric
20
Interface
gei-3/6
Metric
20
ZTE Proprietary and Confidential