Zte ZXR10 ZSR V2 Configuration Manual page 190

ZXR10 ZSR V2 Configuration Guide (IPv6)
By default, an interface is not the border of the PIM domain. When the interface is
set to the border of the PIM domain, no BSR messages can pass the border in any
direction. This function divides the network into different areas of BSR messages
effectively. Other PIM messages can pass the domain border.
The following example shows how to configure a PIM domain border on gei-1/1.
ZXR10(config-mcast-ipv6)#router pim
ZXR10(config-mcast-ipv6-pim)#interface gei-1/1
ZXR10(config-mcast-ipv6-pim-if-gei-1/1)#bsr-border
ZXR10(config-mcast-ipv6-pim-if-gei-1/1)#exit
The intervals of sending Hello messages to PIM-SM neighbors can be set according
to demand.
The following example shows how to configure the intervals of sending PIM Hello
messages on gei-1/1.
ZXR10(config-mcast-ipv6)#router pim
ZXR10(config-mcast-ipv6-pim)#interface gei-1/1
ZXR10(config-mcast-ipv6-pim-if-gei-1/1)#hello-interval 25
ZXR10(config-mcast-ipv6-pim-if-gei-1/1)#exit
6. Configure IPv6 PIM-SM control policy.
Step
1
2
7. Verify the configurations.
Command
ZXR10(config)#
<group-address>][source <source-address>]
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
embedded | static}]
SJ-20140504150128-018|2014-05-10 (R1.0)
Command
ZXR10(config-mcast-ipv6-pim)#
access-list-name >
ZXR10(config-mcast-ipv6-pim)#
<access-list-name>
show ipv6 pim mroute [group
show ipv6 pim mroute summary
show ipv6 pim bsr
show ipv6 pim rp mapping [{bsr | default |
accept-register <
accept-rp
Function
Displays the IPv6 PIM routing table.
Displays the summary information
about the PIM routing table.
Displays the information about the
BSR.
Displays the RP mapping
information advertised by the
router.
14-6
ZTE Proprietary and Confidential
Function
Filters the multicast packets
encapsulated in Register
messages.
Filters the candidate RP
addresses advertised in the
Bootstrap messages.