Zte ZXR10 ZSR V2 Configuration Manual page 302

ZXR10 ZSR V2 Configuration Guide (IPv6)
R1(config-if-gei-1/2)#ipv6 dhcp client address
/*obtain an IPv6 address*/
R1(config-if-gei-1/2)#ipv6 dhcp address zte ::110/112
/*Configure the suffix*/
R1(config-if-gei-1/2)#ipv6 dhcp client pd zte rapid-commit
/*Obtain the IPv6 prefix*/
Configuration Verification
Run the show ipv6 interface<interface-name> command on R1 to check the interface:
R1(config)#show ipv6 interface gei-1/2
Interface gei-1/2
IPv6 is enabled, Hardware is Gigabit Ethernet
Hardware address is 000d.0d00.000c
Index 17
Bandwidth 1000000 Kbits
IPv6 MTU 1500 bytes
inet6 fe80::20d:dff:fe00:c/10
inet6 11:12::1:1/128
inet6 11:11::12:110/112
ND DAD is enabled, number of DAD attempts: 3
ND reachable time is 30000 milliseconds
The client has two IPv6 addresses. One is obtained directly: 11:12::1:1/128. The suffix is
128 bits. The other consists of two parts: the obtained IP prefix and the configured suffix:
11:11::12:110/112.
You can also run the following command on R2 to check the allocated IPv6 addresses and
the prefix:
R2(config)#sho ipv6 dhcp server user
Client DUID: 00030001000D0D00000C
IA NA: IA ID 17, T1 30, T2 48
Address: 11:12::1:1
preferred lifetime 60, valid lifetime 60
expires at 23:52:20 11/01/2000 (30 seconds)
IA PD: IA ID 17, T1 30, T2 48
Prefix: 11:11::12:0/112
preferred lifetime 60, valid lifetime 60
expires at 23:52:49 11/01/2000 (59 seconds)
SJ-20140504150128-018|2014-05-10 (R1.0)
is up, line protocol is up
24-18
ZTE Proprietary and Confidential