Zte ZXR10 ZSR V2 Configuration Manual page 193

R2(config-mcast-ipv6-pim)#interface gei-0/7
R2(config-mcast-ipv6-pim-if-gei-0/7)#pimsm
R2(config-mcast-ipv6-pim-if-gei-0/7)#dr-priority 20
R2(config-mcast-ipv6-pim-if-gei-0/7)#end
R2#configure terminal
R2(config)#ipv6 route 198::/64 199::1
Configuration Verification
Execute the show ipv6 pimsm interface command on R1 to check the interface state, as
shown below.
R1(config)#show ipv6 pim interface
Interface
gei-0/7
Address: fe80::2d0:d0ff:fe06:606
DR
gei-0/9
Address: fe80::2d0:d0ff:fe06:606
DR
Execute the show ipv6 pim neighbor command on R1 to check the neighbor state, as shown
below.
R1(config)#show ipv6 pim neighbor
Neighbor Address(es)
fe80::211:12ff:fe51:ea12
Execute the show ipv6 pim bsr command on R1 to check the BSR state, as shown below.
R1(config)#show ipv6 pim bsr
BSR address: 100::1
Uptime: 00:17:48, BSR Priority :0, Hash mask length:126
Expires:00:01:22
No candidate RP information!
Execute the show ipv6 mroute command on R1 to check the IPv6 multicast routing table.
R1#show ipv6 mroute
IPv6 Multicast Routing Table
Flags:NS:SPT upsend,RT:Reg upsend,F:Forward,
NTP:NTP join,DPU:Damping enable,DPD:Damping del,
(198::2, ff1e::1), TYPE: DYNAMIC, FLAGS:
Incoming interface: gei-0/7, flags:
Outgoing interface list:
gei-0/9, flags: F
SJ-20140504150128-018|2014-05-10 (R1.0)
State Nbr Hello
Count Period Priority
Up 0 30
: fe80::2d0:d0ff:fe06:606
Up 1 30
: fe80::2d0:d0ff:fe06:606
Interface
gei-0/9
Chapter 14 IPv6 PIM-SM Configuration
DR PIM
Silent
20 Disabled
1 Disabled
Uptime Expires
01:02:30 00:01:19
14-9
ZTE Proprietary and Confidential
Mode
S
S
DR Pri
1