Debug Ipv6 Ospf Route; Debug Ipv6 Packet - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
terminal monitor

debug ipv6 ospf route

Use this command to trace route run over the OSPFv3 protocol.
Disable the debugging information with the no command.
Privileged EXEC
debug ipv6 ospf route [ase | ia | install | spf]
no debug ipv6 ospf route [ase | ia | install | spf]
ase | ia | install | spf
If this area is configured, it is invalid by default.
� The platform version 4.6.02 and upgrade versions support this
command.
� You can implement route condition trace with this command to
facilitate troubleshooting.
This example describes how to open all route switches.
ZXR10#debug ipv6 ospf route
terminal monitor

debug ipv6 packet

Use this command to display the information of IPV6 packet re-
ceived and sent by the system. Disable the function with the no
command.
Privileged EXEC
debug ipv6 packet [interface<interface-name>][protocol<pr
otocol>][detail]
no debug ipv6 packet
detail
<interface-name>
<protocol>
If this area is configured, it is disabled by default.
Confidential and Proprietary Information of ZTE CORPORATION
Specific condition of the traced route,
corresponding to route load, calculation, route
outside a region, and router inside a region
Displays packet information as detailed as
possible
The name of the interface
The name of the protocol
Chapter 11 Debugging
89