Policy Routing Configuration Example; Figure 2-5 Policy Routing Configuration Example - Zte ZXR10 5900E Series Configuration Manual

ZXR10 5900E Series Configuration Guide (QoS)

2.4.2 Policy Routing Configuration Example

Configuration Description
As shown in
Because route 200.0.0.0 is not advertised to S1 by S2, policy routing is configured to
transport traffic between S1 and S2.

Figure 2-5 Policy Routing Configuration Example

Configuration Flow
1. Configure an ACL rule for traffic classification. According to the current requirement,
the traffic classification is done on the basis of the destination IP address, so the
ipv4-access-list is used. The TCP packet sent from the server AAA matches the source
IP address 192.168.210.2 and the TCP protocol number. For the IP packet sent from
the PC-A and PC-B device to the PC-C device, the destination IP address is 200.0.0.1.
The PC-A device pings the packet of the server AAA. This packet is an icmp packet
with the destination IP address being 192.168.210.1, and the source IP address being
192.168.101.1.
2. Configure the QoS command that will be redirected to the CPU, and send the TCP
packet sent from the server AAA to the cpu.
3. Configure the policy route, and redirect the packet with the destination IP address
being 200.0.0.1 to the specified next hop.
SJ-20150114102049-008|2015-01-15 (R1.0)
Figure 2-5, PC-A, S2, PC-B and Server AAA are connected to a switch S1.
2-16
ZTE Proprietary and Confidential