Figure 5-2 Topology Of Ripng Route Collection Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual

Chapter 5 RIPng Configuration

Figure 5-2 Topology of RIPng Route Collection Configuration Example

Configuration Flow
1. Establish the networking structure and configure the IPv6 address for the interface,
see Figure 5-2.
2. Enable the RIPng protocol for the interface on R1.
3. Configure the loopback address on R2, collect the route and notify R1.
Configuration Commands
The configuration of R1 is as follows:
R1(config)#interface gei-3/6
R1(config-if-gei-3/6)#ipv6 enable
R1(config-if-gei-3/6)#ipv6 address 3611::11/64
R1(config-if-gei-3/6)#no shutdown
R1(config-if-gei-3/6)#exit
R1(config)#ipv6 router rip
R1(config-ripng)#interface gei-3/6
R1(config-ripng-if-gei-3/6)#ipv6 rip enable
The configuration of R2 is as follows:
R2(config)#interface gei-1/3
R2(config-if-gei-1/3)#ipv6 enable
R2(config-if-gei-1/3)#ipv6 address 3611::10/64
R2(config-if-gei-1/3)#no shutdown
R2(config-if-gei-1/3)#exit
R2(config)#interface loopback5
R2(config-if-loopback5)#ipv6 enable
R2(config-if-loopback5)#ipv6 address 2001:db8:0:10::/64
R2(config-if-loopback5)#exit
R2(config)#interface loopback4
R2(config-if-loopback4)#ipv6 enable
R2(config-if-loopback4)#ipv6 address 2001:db8:0:11::/64
R2(config-if-loopback4)#exit
R2(config)#interface loopback3
R2(config-if-loopback3)#ipv6 enable
R2(config-if-loopback3)#ipv6 address 2001:db8:0:12::/64
R2(config-if-loopback3)#exit
R2(config)#ipv6 router rip
5-11
SJ-20140504150128-018|2014-05-10 (R1.0) ZTE Proprietary and Confidential