Ospfv3 Redistribution Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual

ZXR10 ZSR V2 Configuration Guide (IPv6)
R1#ping6 3550::52
sending 5,100-byte ICMP echo(es) to 3555:0:0:0:0:0:0:52,timeout is 2 second(s).
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 2/3/4 ms.

6.3.2 OSPFv3 Redistribution Configuration Example

Configuration Description
As shown in
interfaces, R1 and R2 establish the link in area 0 whereas R2 and R3 establish a link
with each other in area 10 to advertise their respective loopback address route, and R1
redistributes the direct route.
Figure 6-2 Topology of OSPFv3 Configuration Example 2
Configuration Flow
1. Enable the IPv6 protocol on each interface, configure IPv6 addresses, configure
loopback interfaces, enable IPv6 on the loopback interfaces, and configure IPv6
addresses for the loopback interfaces.
2. Configure OSPFv3.
3. Add the interfaces to OSPFv3. R1 and R2 establish a link with each other in area 0,
R2 and R3 establish a link with each other in area 10, and R1 redistributes the direct
route.
4. Check and verify the configuration results: Neighbor relationships are correctly
established among the routers, each router can learn the routes advertised by the
other two routers, and each router can ping the loopback interfaces of the other two
routers successfully.
Configuration Commands
The configuration on R1 is as follows:
SJ-20140504150128-018|2014-05-10 (R1.0)
Figure 6-2, R1 and R2 establish a link with each other via the direct connection
6-14
ZTE Proprietary and Confidential