Ipv6 Pim-Sm Configuration Example; Figure 14-1 Pim-Sm Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual

Command
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
ZXR10(config)#
<ipv6-address>]
ZXR10(config)#
– End of Steps –

14.3 IPv6 PIM-SM Configuration Example

Configuration Description
As shown in
to R1. It is required to configure BSR neighbors and CRP.

Figure 14-1 PIM-SM Configuration Example

Configuration Flow
1. Configure addresses of related interfaces.
2. Enter multicast configuration mode.
3. Enter PIM configuration mode.
4. Set the loopback5 interface on R2 to CRP and BSR.
5. Enable PIM-SM on interfaces.
6. Configure a unicast route to the RP on R1. Configure a unicast route to the multicast
source on R2 (In this example, static route or IGP can be used).
SJ-20140504150128-018|2014-05-10 (R1.0)
show ipv6 pim rp hash <group-address>
show ipv6 pim interface [<interface-name>]
show ipv6 pim neighbor [<interface-name>]
show ipv6 pim nexthop [dest-address
show ipv6 pim traffic [<interface-name>]
Figure 14-1, an MLD group connects to R2, and a multicast source connects
Chapter 14 IPv6 PIM-SM Configuration
Function
Displays the RP information
selected by a specific multicast
group.
Displays the interface on which PIM
is configured.
Displays the neighbor information
about an IPv6 PIM interface.
Displays the IPv6 PIM next hop
information.
Displays traffic statistical information
about the IPv6 PIM protocol.
14-7
ZTE Proprietary and Confidential