Figure 15-3 Ip Source Route Option Processing Configuration Example - Zte ZXR10 ZSR V2 Configuration Manual (System Management

Maintenance Commands
To display the IP source route option configuration, run the following command on the
ZXR10 ZSR V2:
Command
show running-config ip all
ZXR10#
Refer to 15.1 Configuring ICMP Fast Response
packet sending and receiving.
Configuration Example
l
Configuration Description
As shown in
processing function.

Figure 15-3 IP Source Route Option Processing Configuration Example

l
Configuration Flow
1. Configure IGP and unicast routes so that the routers can ping each other
successfully.
2. Configure source route options on R1.
3. Make the source send IP packets with correct IP options.
4. Make the source send IP packets with incorrect IP options.
l
Configuration Command
Run the following commands on R1:
R1(config)#interface gei-1/1
R1(config-if-gei-1/1)#no shutdown
R1(config-if-gei-1/1)#ip address 10.10.20.1 255.255.255.0
R1(config-if-gei-1/1)#exit
R1(config)#router ospf 1
R1(config-ospf-1)#network 10.10.10.0 0.0.0.255 area 0
R1(config-ospf-1)#network 10.10.20.0 0.0.0.255 area 0
R1(config-ospf-1)#exit
R1(config)#ip source-route
Run the following commands on R2:
SJ-20140504150128-007|2014-05-10 (R1.0)
Figure 15-3, it is required to configure the IP source route option
15-5
Chapter 15 Network Layer Detection
Function
Displays whether the IP source route option
processing function is configured.
for maintenance commands relevant to
ZTE Proprietary and Confidential