Zte ZXR10 ZSR V2 Configuration Manual page 93

Command
ZXR10(config-isis-process-id)#
ZXR10(config-isis-process-id)#
| level-1-2}
ZXR10(config-isis-process-id)#
ZXR10(config-isis-process-id)#
ZXR10(config-isis-process-id)#
encrypt < key>}[ level-1 | level-2]
ZXR10(config-isis-process-id)#
ZXR10(config-isis-process-id)#
ZXR10(config-isis-process-id)#
enable}
ZXR10(config-isis-process-id)#
3. Configure IS-ISv6 global parameters in IS-ISv6 address family mode.
Step
1
SJ-20140504150128-018|2014-05-10 (R1.0)
Command
ZXR10(config-isis-process-id)#
Chapter 7 IS-ISv6 Configuration
ignore-lsp-errors
is-type {level-1 | level-2-only
max-lsp-lifetime <interval>
metric-style {narrow | wide}
authentication {< key>|
disable-snp-authentication
enable-snp-authentication
hostname dynamic{disable |
hello padding
address-family ipv6
7-3
ZTE Proprietary and Confidential
Function
Sets the IS-ISv6 to ignore LSP
checksum errors.
Configures the routing level
for a router.
Configures the maximum LSP
life time (in seconds), range: 1
to 65535, default: 1200.
Configures the metric style of
the router.
The narrow mode uses only 6
bits to carry the metric value,
whereas the wide mode uses
24 bits to carry it and supports
more TLVs to be carried.
Configures the LSP/SNP
authentication of IS-ISv6.
Disables SNP authentication.
Run this command when only
LSP authentication needs to
be enabled after LSP/SNP
authentication is configured.
Enables SNP authentication.
Run this command if SNP
authentication needs to be
enabled again.
Configures the dynamic host
name mapping function of
IS-ISv6.
Pads 0 to each hello packet
sent on the interface until the
packet size equals the MTU
value of the interface.
Function
Enters IPv6 address-family
configuration mode.