Configuring Isatap Tunnels; Figure 16-9 Isatap Tunnel Principle - Zte ZXR10 ZSR V2 Configuration Manual

ZXR10 ZSR V2 Configuration Guide (IPv6)
the packet. If the matched tunnel entity is found, the IPv4 header encapsulated is
removed, and the left IPv6 packet is handled according to the IPv6 packet receiving
flow.
Figure 16-9

Figure 16-9 ISATAP Tunnel Principle

16.2.2 Configuring ISATAP Tunnels

This procedure describes how to configure ISATAP tunnels.
Steps
1. Configure an ISATAP tunnel.
Step
1
2
3
4
5
6
SJ-20140504150128-018|2014-05-10 (R1.0)
shows the ISATAP tunnel principle.
Command
interface v6_tunnel<tunnel_no>
ZXR10(config)#
ZXR10(config-if-v6_tunnel)#
ZXR10(config-if-v6_tunnel)#
/ prefix-len> eui-64
ipv6-tunnel-config
ZXR10(config)#
ZXR10(config-v6_tunnel)#
<interface-byname>|<interface-name>}
ZXR10(config-ipv6-tunnel-if-v6_tunnel)#
mode ipv6ip isatap
ipv6 enable
ipv6 address <addrprefix
interface {byname
tunnel
16-14
ZTE Proprietary and Confidential
Function
Creates an IPv6 tunnel
interface.
Enables IPv6.
Configures an eui-64 address
on an interface for an ISATAP
tunnel.
Enters IPv6 tunnel
configuration mode.
Enters IPv6 tunnel interface
configuration mode. The
interface alias and interface
name can contain up to 32
characters.
Sets the tunnel mode to
isatap.