Zte ZXR10 ZSR V2 Configuration Manual page 82

ZXR10 ZSR V2 Configuration Guide (IPv6)
3. Add the interfaces to OSPFv3 area 0.
4. Check and verify the configuration results: Neighbors are correctly established
between the two routers, each router can learn the routes advertised by the peer
router, and each router can ping the peer loopback interface successfully.
Configuration Commands
The configuration on R1 is as follows:
R1(config)#interface gei-3/6
R1(config-if-gei-3/6)#no shutdown
R1(config-if-gei-3/6)#ipv6 enable
R1(config-if-gei-3/6)#ipv6 address 3611::11/64
R1(config-if-gei-3/6)#exit
R1(config)#interface loopback5
R1(config-if-loopback5)#ipv6 enable
R1(config-if-loopback5)#ipv6 address 3555::52/64
R1(config-if-loopback5)#exit
R1(config)#ipv6 router ospf 1
R1(config-ospfv3-1)#router-id 11.11.11.11
R1(config-ospfv3-1)#interface gei-3/6 area 0
R1(config-ospfv3-1-if-gei-3/6)#exit
R1(config-ospfv3-1)#interface loopback5 area 0
R1(config-ospfv3-1-if-loopback5)#exit
R1(config-ospfv3-1)#exit
The configuration on R2 is as follows:
R2(config)#interface gei-1/3
R2(config-if-gei-1/3)#no shutdown
R2(config-if-gei-1/3)#ipv6 enable
R2(config-if-gei-1/3)#ipv6 address 3611::10/64
R2(config-if-gei-1/3)#exit
R2(config)#interface loopback5
R2(config-if-loopback5)#ipv6 enable
R2(config-if-loopback5)#ipv6 address 3550::55/64
R2(config-if-loopback5)#exit
R2(config)#ipv6 router ospf 1
R2(config-ospfv3-1)#router-id 10.10.10.10
R2(config-ospfv3-1)#interface gei-1/3 area 0
R2(config-ospfv3-1-if-gei-1/3)#exit
R2(config-ospfv3-1)#interface loopback5 area 0
R2(config-ospfv3-1-if-loopback5)#exit
R2(config-ospfv3-1)#exit
SJ-20140504150128-018|2014-05-10 (R1.0)
6-12
ZTE Proprietary and Confidential