Zte ZXR10 GER User Manual page 335

1. To create VFI, use command vfi<vfi-name> in global
configuration mode. This is shown in Table 355.
T 3 5 5 V C
A B L E F I O M M A N D
Command Command
Format Mode
vfi<vfi-
global config
name>
Result: This creates VFI.
2. To enable MPLS,
configuration mode. This is shown in Table 356.
T 3 5 6 M I
A B L E P L S D
Command Command
Format Mode
mpls ip global config
Result: This enables MPLS.
3. To create VCID, use command vcid <vcid-number> in VFI
configuration mode. This is shown in Table 357.
T 3 5 7 V C
A B L E C I D O M M A N D
Command Command
Format Mode
vcid
<vcid- VFI
number>
Result: This creates VCID.
4. To configure
<ethernet|ethernet-vlan> in VFI configuration mode. This is
shown in Table 358.
T 3 5 8 P
A B L E W T Y P E
Command Format
pwtype
<ethernet|ethernet-
vlan>
Result: This configures PWTYPE.
5. To create peer, use command peer {<peer-router-id> ＜-
1024＞|spoke ＜1-1024}＞ in VFI configuration mode. This
is shown in Table 359.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 22 VPLS Configuration
Command Function
This creates VFI
use command
C
O M M A N D
Command Function
This enables MPLS
Command Function
This creates VCID
PWTYPE, use
C
O M M A N D
Command
Command Function
Mode
VFI This configures PWTYPE
mpls ip in global
command pwtype
313