E1 Encapsulation-Vt-2 - Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
Purpose
Prerequisite
114 Confidential and Proprietary Information of ZTE CORPORATION
Command Command
Format Mode
e1< E1
number >
clock
source
Result: This sets the clock source of E1 channel.
5. To set frame as a sonet, use sonet command in interface
configuration mode, as shown in Table 135.
T 1 3 5 S
A B L E O N E T
Command Command
Format Mode
Interface
sonet
config
Result: This sets the framing as a sonnet.
6. To enter into the sts-1 configuration mode, use sts-1
command in global configuration mode, as shown in Table
136.
T 1 3 6 S - 1 C
A B L E T S
Command Command
Format Mode
sts-1 global config
Result: This enters into the sts-1 configuration mode.
7. To select the mapping mode of sts-1, vt-15 or vt-2, use
mode command in interface configuration mode, as shown
in Table 137.
T 1 3 7 M C
A B L E O D E
Command Command
Format Mode
Interface
mode
config
Result: This select the mapping mode of sts-1, vt-15 or vt-2.
E
ND OF STEPS

E1 Encapsulation-VT-2

Refer to below procedure for configuring E1 encapsulation in
case of VT-2 ZTE ZXR10 GER router.
Router Command Line Interface has been accessed.
Command Function
F
R A M I N G
Command Function
This sets the framing as a sonet
O M M A N D
Command Function
This enter into the sts-1
configuration mode
O M M A N D
Command Function
This select the mapping mode
of sts-1, vt-15 or vt-2