Zte ZXR10 GER User Manual page 162

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
140 Confidential and Proprietary Information of ZTE CORPORATION
Result: This enables to create multilink interface and to
enter into it.
3. To configure an IP address of an interface, use ip address
<ip-address>
interface config mode as shown in Table 168.
T 1 6 8 I A
A B L E P D D R E S S
Command Command
Format Mode
ip address Interface
<ip-
address>
<net-mask>
[<broadcast-
address>]
Result: This configures an ip address of an interface.
4. To bind physical link of multiple E1s use multilink-group
<multilink-number> command in interface configuration
mode as shown in Table 169.
T 1 6 9 M - L
A B L E U L T I
Command Command
Format Mode
multilink-
group
Interface
<multilink-
number>
Result: This sets multiple E1 links to a group.
5. To configure end point string of multilink, use ppp multilink
endpoint string
configuration mode as shown in Table 170.
T 1 7 0 P P P M
A B L E
Command
Format
ppp multilink
endpoint
string <string>
Result: This sets end point string of multilink.
E
ND OF STEPS
Example: As shown in Figure 76, routers R1 and R2 are bound
and interconnected in channelized E1 mode. MPPP is configured.
<net-mask> [<broadcast-address>]
C
O M M A N D
Command Function
This configures an ip address of
an interface
G C
I N K R O U P O M M A N D
Command Function
This binds link to multilink
<string> command
E P C
U L T I L I N K N D O I N T O M M A N D
Command Command Function
Mode
This configures end point string
Interface
of multilink
in
in interface