Configuring Multilink; Figure 67 Smart-Group Example - Zte ZXR10 GER User Manual

F
I G U R E
ZXR10
Configuration of ZXR10 GER
ZXR10(config)#interface smartgroup1
ZXR10(config-if)#ip address 192.168.1.1 255.255.255.252
ZXR10(config)#interface fei_8/1
ZXR10(config-if)#smartgroup 1 mode on
ZXR10(config)#interface fei_8/2
ZXR10(config-if)#smartgroup 1 mode on
Configuration of ZXR10 routing switch:
T64C(config)#smarttrunk create st.1 protocol no-protocol
T64C(config)#smarttrunk add ports et.3.1-2 to st.1
T64C(config)#interface create ip to-zxr10 address-netmask
192.168.1.2/30 port st.1

Configuring Multilink

To increase bandwidth, multiple E1 physical links can be bound
Background
into a logical link and logical interface generated in this way is
called multilink interface.
In ZXR10 GER, a multilink interface can be bound with a
maximum of sixteen E1 interfaces in same slot.
Purpose This procedure describes how to do multilink on ZTE ZXR10 GER.
Prerequisite Router Command Line Interface has been accessed.
Steps 1. To enter into configuration mode, use config terminal
2. To create multilink interface and to enter into it, use
6 7 S - G E
M A R T R O U P
192.168.1.2/30
smtgtp_8/1
192.168.1.1/30
command in privilged mode, as shown in Table 118.
T 1 1 8 C T
A B L E O N F I G E R M I N A L
Command Command
Format Mode
config Exec
terminal
Result: This enables to enter into global configuration mode.
interface <interface-number>
configuration, as shown in Table 119.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 Interface Configuration
X A M P L E
st.1
ZXR10 routing switch
C
O M M A N D
Command Function
Enters into global configuration
mode
command in global
107