Rip Enhanced Configuration; Figure 85 Basic Rip Configuration - Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
Purpose
Prerequisite
Steps
174 Confidential and Proprietary Information of ZTE CORPORATION
<ip-address> refers to format 0.0.0.0.
<wildcard-mask> A wildcard mask is a 32-bit quantity used
in conjunction with an Internet address to
which bits in an Internet address should be
comparing that address with another Internet address. This
refers to filter out a subnet.
Result: This configures RIP interfaces between certain
numbers of a specified network address.
E
ND OF STEPS
Example: As shown in Figure 85 , RIP runs on router R1 and
router R2.
F 8 5 B R C
I G U R E A S I C I P
10.1.0.1/16
192.168.1.1/24
R1
Configuration of R1:
ZXR10_R1(config)#router rip
ZXR10_R1(config-router)#network 10.1.0.0 0.0.255.255
ZXR10_R1(config-router)#network 192.168.1.0 0.0.0.255
Configuration of R2:
ZXR10_R2(config)#router rip
ZXR10_R2(config-router)#network 10.2.0.0 0.0.255.255
ZXR10_R2(config-router)#network 192.168.1.0 0.0.0.255

RIP Enhanced Configuration

This below procedure delivers information about enhanced RIP
configuration
Router Command Line Interface has been accessed.
RIP is running on a network as described in above basic IP
configuration.
1. To adjust timer for better rip performance in some cases, use
command timers
<holddown> <flush> in RIP config mode as shown in
Table 211. To restore the default timers, use the no form of
this command.
O N F I G U R A T I O N
192.168.1.2/24
R2
basic <update>
determine
ignored when
10.2.0.1/16
<invalid>