Zte ZXR10 GER User Manual page 345

T 3 6 9 I T
A B L E G P E
Command Command
Format Mode
mpls
traffic-eng
router-id OSPF config
<interface-
name>
mpls
traffic-eng
OSPF config
area
<area-id>
capability
OSPF config
opaque
Result: This configures an IGP protocol to transmit TE.
5. To configure the tunnel interface for TE, use the following
commands:
i. To enter into tunnel interface mode, use interface
tunnel <1-64> command in global configuration mode
as shown in Table 370.
ii. To set the tunnel mode into mpls, use tunnel mode
mpls traffic-eng
configuration mode as shown in Table 370.
iii. To define the IP address of the tunnel destination
use tunnel destination {ipv4 | ipv6} <ip-address>
command in Table 370.
iv. To set the bandwidth reserved for tunnel use tunnel
mpls traffic-eng bandwidth <bandwidth> command in
tunnel interface configuration mode as shown in Table
370.
v. To configure ERO in order to obtain dynamic selection or
static configuration of an explicit path, use tunnel mpls
traffic-eng path-option <number> {dynamic | explicit
{name <path-name> | identifier <id>}} in tunnel
interface configuration mode as shown in Table 370.
vi. To record the routes used by tunnel, use tunnel mpls
traffic-eng record-route command in tunnel interface
configuration mode as shown in Table 370.
T 3 7 0 T
A B L E U N N E L
Command Format
interface
tunnel<1-64>
tunnel mode mpls
traffic
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 23 Traffic Engineering Configuration
C C
O N F I G O M M A N D
Command Function
This sets the router id for TE
signaling
This sets an area for TE
signaling
This sets the OSPF opaque
feature
command
C C
O N F I G O M M A N D
Command
Mode
Global config
Tunnel
interface
config
in tunnel interface
router,
Command Function
This configures tunnel
interface
This sets the tunnel for
MPLS TE
323