Configuring Administrative Distance - Zte ZXR10 GER User Manual

Refer to below procedure for configuration of redistribution of
other routing protocols into OSPF.
Prerequisites
Steps 1. Use the redistribute command to control the redistribution
E
ND OF STEPS
Related For additional information on OSPF additional configurations,
Information please refer to below procedures.

Configuring Administrative Distance

Introduction The
information source. Normally, the administrative distance is an
integer ranging from 0 to 255. Higher value indicates lower
reliability. If the administrative distance is 255, it indicates that
the source of the routing information is unreliable, so the related
route will be neglected.
ZXR10 GER can define the administrative distances of three
types of routes of OSPF: Internal route, external route type 1
and external route type 2. By default, the administrative of all
the three types of routes are 110.
Purpose Refer to below procedure for configuration of redistribution of
other routing protocols into OSPF.
Prerequisites
Steps 1. For modifying the administrative distance of OSPF, use
Router Command Line Interface has been accessed.
OSPF is running on a network as described in above basic
OSPF configuration.
of routes of other routing protocols into an OSPF autonomous
system in OSPF route mode as shown in Table 249.
T 2 4 9 R
A B L E E D I S T R I B U T E
Command
Format
redistribute
<protocol> [as
<as-no>] [peer
<peer-address>]
[tag <tag-value>]
[metric <value>]
[metric-type
<type>] [route-
map <map-tag>]
Result: This establish a process of redistribution of other
routing protocols into OSPF.
administrative distance
Router Command Line Interface has been accessed.
OSPF is running on a network as described in above basic
OSPF configuration.
distance ospf {[internal <distance>] [ext1 <distance>]
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 14 OSPF Configuration
C
O M M A N D
Command Command Function
Mode
This controls the
redistribution of routes
(these routes meet the
relative conditions) of
Route other protocols into an
OSPF autonomous system.
After the command is
carried out, the router
becomes an ASBR
stands for the reliability of
205