E1 Encapsulation- Au-4; As Shown In Table 129 - Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
Purpose
Prerequisite
Steps
112 Confidential and Proprietary Information of ZTE CORPORATION
2. To create a CPOS interface in T1 encapsulation, use format
tug-2<Vtg number> t1< T1 number > channel-group 1
timeslots <1-24>. Command in interface configuration mode,

as shown in Table 129.

T 1 2 9 T 1 E
A B L E N C A P S U L A T I O N S
Command Command
Format Mode
format tug-
2<Vtg
number>
t1< T1
Interface
number >
config
channel-
group 1
timeslots <1-
24>.
Result: This creates a cpos interface in the T1 encapsulation.
3. To set the clock source of T1 channel, use tug-2<Vtg
number> t1< T1 number >clock source command in
interface configuration mode, as shown in Table 130.
T 1 3 0 T 1 C
A B L E L O C K
Command Command
Format Mode
tug-2<Vtg
number>
t1< T1 Interface
number config
>clock
source
Result: This sets the clock source of T1 channel.
E
ND OF STEPS

E1 Encapsulation- AU-4

Refer to below procedure for configuring E1 encapsulation in
case of AU-4 on ZTE ZXR10 GER router.
Router Command Line Interface has been accessed.
1. To enter into the tug-3 configuration mode, use au-4 1 tug-
3 command in interface configuration mode, as shown in
Table 131.
C I
P O S N T E R F A C E
Command Function
This creates a cpos interface in
the T1 encapsulation
S C
O U R C E O M M A N D
Command Function
This sets the clock source of T1
channel