Multilink Point To Point Protocol (Mppp) - Zte ZXR10 GER User Manual

Configuration of R2:
ZXR10_R2(config)#interface pos3_3/1
ZXR10_R2(config-if)#ip address 192.168.1.2 255.255.255.252
ZXR10_R2(config-if)#ppp authentication chap
ZXR10_R2(config-if)#ppp chap hostname ZXR10
ZXR10_R2(config-if)#ppp chap password hello
ZXR10_R2(config-if)#ppp open
Multilink Point to Point Protocol
(MPPP)
As higher-speed services are deployed, Multilink-PPP provides a
Background
standardized method for spreading traffic across multiple WAN
links, while providing multi vendor interoperability, packet
fragmentation and proper sequencing and load balancing on
both inbound and outbound traffic.
Upon data sending, IP packets are first encapsulated into PPP
frame format and then encapsulated frame are segmented into
certain data fragments. Each data fragment added with header
of MPPP is encapsulated into MPPP frame format.
Purpose This procedure describes how to do multilink PPP on ZTE ZXR10
GER.
Prerequisite Router CLI (Privileged Mode) has been accessed.
Steps
1. Enter into configuration mode by writing config terminal
2. To create multilink interface and to enter into it, use
command in global configuration mode as shown in Table
166.
T 1 6 6 C T
A B L E O N F I G E R M I N A L
Command Command
Format Mode
config Exec
terminal
Result: This enables to enter into global configuration mode.
interface <interface-number>
configuration mode as shown in Table 167.
T 1 6 7 M
A B L E U L T I L I N K
Command Command
Format Mode
interface
Global
<interface-
number>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 Link Protocol Configuration
C
O M M A N D
Command Function
Enters into global configuration
mode
command
I C
N T E R F A C E O M M A N D
Command Function
Creates a multilink interface and
enters the interface
configuration mode
in global
139