Zte ZXR10 GER User Manual page 195

Metric—Indicates how many internetwork hops (routers)
have been traversed in trip to destination. This value is
between 1 and 15 for a valid route or 16 for an unreachable
route.
Purpose This procedure describes how to configure RIP on ZTE ZXR10
GER.
Prerequisite Router Command Line Interface has been accessed.
Steps 1. Enter into configuration mode by writing config terminal
2. To enable RIP, use the following command,as shown in Table
3. To associate a network with RIP routing process, use
NOTE: Up to 25 occurrences of AFI, Address and Metric
Fields are permitted in single IP RIP Packet. That is, up to 25
routing table entries can be listed in a single RIP packet. If
the AFI specifies an authenticated message, only 24 routing
table entries can be specified.
Given that individual table entries aren't fragmented into
multiple packets, RIP does not need a mechanism to again
make a sequence datagram's bearing routing table updates
from neighboring routers.
command in global configuration mode as shown in Table
208.
T 2 0 8 C T
A B L E O N F I G E R M I N A L
Command Command
Format Mode
config Exec
terminal
Result: This enables to enter into global configuration mode.
209.
T 2 0 9 R R
A B L E O U T E R I P
Command Command
Format Mode
router rip config
Result: This configures RIP routing process.
command network <ip address> in
shown in Table 210.
T 2 1 0 N C
A B L E E T W O R K
Command Command
Format Mode
network <ip- RIP config
address>
<wildcard-
mask>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 13 RIP Configuration
C
O M M A N D
Command Function
Enters into global configuration
mode
C
O M M A N D
Command Function
This establish rip routing process
W
O M M A N D I N D O W
Command Function
This designates a network
table for RIP routing
RIP config mode as
173