Zte ZXR10 GER User Manual page 201

Default Metric A default metric helps solve the problem of redistributing routes
with incompatible metrics. Whenever metrics do not
using a default metric provides a reasonable substitute and
enables the redistribution to proceed.
Important! When enabled, the default-metric command applies
a metric value of 0 to redistributed connected routes. The
default-metric command does not override metric values that
are applied with the redistribute command.
Result: This helps to configure metric values for other
protocols.
E
Version ZXR10 GER supports RIPv1 and RIPv2 (RIPv2 is used by default).
Configuration
1. To specify a RIP version used globally by the router, use
current routing protocol to use the same metric value for all
redistributed routes.
ND OF STEPS
version command in RIP router configuration mode, as
shown in Table 220. Use the no form of this command to
restore the default value.
T 2 2 0 R V
A B L E I P E R S I O N
Command
Format
version {1|2}
ip rip receive
version {1|2}
[1|2]
ip rip send
version {1|2
{broadcast
multicast}}
{1|2} specifies RIP version 1 and RIP version 2.
To specify RIP versions used on an interface basis, use
the ip rip receive version and ip rip send version
commands.
ip rip receive version command is used to override the
default behavior of RIP as specified by the version command.
This command applies only to the
configuration. There can be configuration for accepting both
the versions.
ip rip send version command to override the default
behavior of RIP as specified by the router version command.
This command applies only to the interface configuration.
Result: These commands specify RIP versions for receiving
and sending routing updates.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 13 RIP Configuration
C W
O M M A N D I N D O W
Command Command Function
Mode
RIP Config This designates the RIP
version used in a router
globally
RIP Config This designates the RIP
version received on an
interface
RIP Config
This designates the RIP
version sent on an interface
convert,
routing
interface
179