Fr Maintenance And Diagnosis - Zte ZXR10 GER User Manual

ZXR10 GER (V2.6.03) General Excellent Router User Manual Volume-I
Purpose
Prerequisite
Steps
144 Confidential and Proprietary Information of ZTE CORPORATION
5. To configure the LMI signaling format, use the following
command, as shown in Table 176.
T 1 7 6 F
A B L E R A M E
Command Command
Format Mode
frame-relay
Interface
lmi-type
configuration
<lmi-type>
Result: This configures the LMI signaling format.
6. Set the FR mode (point-to-point and point-to- multipoint).
Following command is used. frame-relay interface-mode
<mode>.
7. Configure address mapping
i. The following command is used in the point-to-point
mode and used to define DLCI mapping between the local
end and the peer end. Following command is used.
frame-relay interface-dlci <dlci>
ii. The following command is used in the point-to-multipoint
mode and
destination protocol address and the DLCI connecting the
destination address. Following command is used. frame-
relay map ip <ip-addr> <dlci> [<encap>]
Here, the IP address should be configured as the peer IP
Note:
address. At present, the following two encapsulation modes are
supported: ietf and cisco (default: ietf).
E
ND OF STEPS

FR Maintenance and Diagnosis

Refer to below procedure for configuring FR on ZTE ZXR10 GER
router.
Router Command Line Interface has been accessed.
1. To display FR lmi information, use show frame-relay lmi
[interface <interface-number>] command in privileged
mode, as shown in Table 177.
T 1 7 7 F
A B L E R A M E
Command Command
Format Mode
frame-relay
Interface
lmi-type
configuration
<lmi-type>
Result: This displays the FR lmi information.
R L T
E L A Y M I Y P E
Command Function
This configures the LMI
signaling format
used to define
R L T C
E L A Y M I Y P E O M M A N D
Command Function
This displays the FR lmi
information
mapping between the