Zte ZXR10 GER User Manual page 179

Purpose
Refer to below procedure for IP address on ZTE ZXR10 GER
router.
Prerequisite Router Command Line Interface has been accessed.
Steps 1. Enter into configuration mode by writing config terminal
2. To enter into interface configuration mode, use interface
3. To configure an IP address of an interface, use ip address
address. The address serves as default route in routing table.
255.255.255.255 is a destination address used for broadcast
and cannot serve as a source address.
127. X.X.X is called loopback address. Even if actual IP
address of host is unknown, address still can be used to
stand for the "local host".
Only IP addresses with host bits being all "0" indicate
network itself. An IP address with host bits being all "1"
serves as broadcast address of the network.
For a legal host IP address, the network part or the host part
must not be all "0" or all "1".
command in global configuration mode as shown in Table
196.
T 1 9 6 C T
A B L E O N F I G E R M I N A L
Command Command
Format Mode
config Exec
terminal
Result: This enables to enter into global configuration mode.
<interface-number> command in global configuration mode
as shown in Table 197.
T 1 9 7 I
A B L E N T E R F A C E
Command Command
Format Mode
interface
<interface- Global config
number>
Result: This enables to enter into interface configuration
mode.
<ip-address> <net-mask>
interface config mode as shown in Table 198.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 11 Network Protocol Configuration
C
O M M A N D
Command Function
Enters into global configuration
mode
C C
O N F I G O M M A N D
Command Function
This enters into interface
configuration mode
[<broadcast-address>] in
157