Garmin G3X Installation Manual page 91

GDU 46X Panel Cutout Drawing
Ensure the Page Scaling setting
is set to NONE when printing
this page. Verify dimensions
of printed template are
accurate before cutting panel.
For corner holes, center punch and drill
(#36) / tap (6/32) to create threaded holes
drill out with #25 drill bit and use Garmin
nut-plate P/N 115-01725-01.
The outline in this drawing is identical
to the outline of the actual bezel.
190-01115-01
Revision AA
IMPORTANT!
OR
.29 in .29 in
7.35 mm (4X) 7.35 mm
Cut out panel
to inside line
7.29 in 7.29 in
185.10 mm 185.10 mm
10.31 in 10.31 in
262.00 mm 262.00 mm
(4X)
.29 in .29 in
R7.35 mm (4X) R7.35 mm
.29 in .29 in
7.35 mm (4X) 7.35 mm
Figure 8-6 GDU 46X Panel Cutout Drawing
G3X Installation Manual - GDU 46X Installation
(4X)
(4X)
Page 8-8