Garmin G3X Installation Manual page 6

Hide thumbs Also See for G3X:
Table of Contents

Advertisement

1. FCC
Contains FCC ID: QOQWT32I
NOTE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter meets both portable and mobile limits as demonstrated in the RF Exposure Analysis. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter except
in accordance with FCC multi-transmitter product procedures.
2. IC
Contains IC: 5123A-BGTWT32I
NOTE
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme aux normes RSS sans licence d'Industrie Canada. Son fonctionnement est
soumis aux conditions suivantes : (1) cet appareil ne doit pas causer d'interférences et (2) doit accepter
toute interférence,y compris les interférences pouvant entraîner un fonctionnement indésirable de
l'appareil.
NOTE
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio
interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Selon les réglementations d'Industrie Canada, cet émetteur radio ne doit fonctionner qu'avec une antenne
d'une typologie spécifique et d'un gain maximum (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Pour réduire les éventuelles perturbations radioélectriques nuisibles à d'autres utilisateurs, le type
d'antenne et son gain doivent être choisis de manière à ce que la puissance isotrope rayonnée équivalente
(P.I.R.E.) n'excède pas les valeurs nécessaires pour obtenir une communication convenable.
190-01115-01
G3X/G3X Touch Installation Manual
Rev. AA
Page iv

Advertisement

Table of Contents
loading

Table of Contents