Jackscrew Backshell Installation Instructions - Garmin G3X Installation Manual

22.3 Jackscrew Backshell Installation Instructions

22.3.1 Shield Block Installation Parts
Table 22-5 and Table 22-6 list the parts needed to install a Shield Block, the item numbers in these tables
correspond to Figure 22-5. Parts listed in Table 22-5 are supplied in the LRU Connector Kits (see
Table 1-30). Parts listed in Table 22-6 are to be provided by the installer.
Table 22-5 Parts supplied for a Shield Block Installation
Item #
1 Cast Backshell Housing
6 Contacts
12 Clamp
13 Screw,4-40x.375,PHP,SS/P,w/Nylon
14 Cover
15 Screw,4-40x.187,FLHP100,SS/P,w/Nylon
Table 22-6 Parts not supplied for a Shield Block Installation
Item #
Multiple Conductor Shielded Cable (2-conductor shown in
2
Figure 22-5)
3 Drain Wire Shield Termination (method optional)
Braid, Flat (19-20 AWG equivalent, tinned plated copper strands
4
36 AWG, Circular Mil Area 1000 -1300)
5 Floating Shield Termination (method optional)
Ring terminal, #8, insulated, 18-22 AWG
7 Ring terminal, #8, insulated, 14-16 AWG
Ring terminal, #8, insulated, 10-12 AWG
Screw, PHP, 8-32x.312", Stainless
8
Screw, PHP, 8-32x.312", Cad Plated Steel
Split Washer, #8, (.045" compressed thickness) Stainless
9
Split Washer, #8, (.045" compressed thickness) Cad-plated steel
Flat Washer, Stainless, #8, .032" thick, .174"ID, .375" OD
10
Flat washer, Cad-plated Steel, #8, .032" thick, .174"ID, .375" OD
11 Silicon Fusion Tape
190-01115-01
Rev. AA
Description
Description
G3X/G3X Touch Installation Manual - Connector Installation Instructions
(Figure 22-5)
GPN or MIL spec
125-00175-00
336-00094-00
115-01078-04
211-60234-10
115-01079-04
211-63234-06
(Figure 22-5)
GPN or MIL spec
Parts used depend on
method chosen
Parts used depend on
method chosen
Parts used depend on
method chosen
Parts used depend on
method chosen
MS25036-149
MS25036-153
MS25036-156
MS51957-42
MS35206-242
MS35338-137
MS35338-42
NAS1149CN832R
NAS1149FN832P
-
Page 22-6