Figure 4-4. Front Panel Retaining Strip - Beckman Coulter Avanti J-20 XP Instruction Manual

Troubleshooting
To replace the panel on the centrifuge,
Action
1. Holding the panel at the top
(with the instrument label
facing out), insert the three
grooved brackets on the
bottom inside of the door
over the front panel retaining
strip (see Figure 4-4). Push
the top of the front panel into
place.
2. Hold the left top edge in
place and insert the Allen
wrench through the hole.
Turn to the right (clockwise)
about one-half turn, until you
reach a stop.
3. Repeat step 2 on the
right side.
4-10
Result
Retaining
Strip

Figure 4-4. Front Panel Retaining Strip

The latch engages.
The second latch engages.