Control Panel; Keys; Displays - Beckman Coulter Optima L Series Instructions For Use Manual

Description

Control Panel

Control Panel
Figure 1.1 shows the front control panel. Refer to this illustration to locate the keys and displays
described below.
Figure 1.1 The Control Panel
4
5
1. Parameter Keys
2. Keypad
3. Activation Keys

Keys

Parameter keys are used to enter the run conditions. They include
of the keypad and
Activation keys are designated to control specific ultracentrifuge functions. These are
and
START STOP
section.)
The keypad is used for entering numerical values. In addition to keys 0 through 9, the keypad
includes a
CE

Displays

Digital displays indicate rotor speed, run time, rotor temperature, the ω
mode), and the selected program number (if used). The displays serve a dual purpose.
1-2
SPEED–RPM TIME–HR:MIN
VACUUM–
w
2
t
ACCEL DECEL HOLD
X 10,000
4. Location of Diagnostic Messages
5. Parameter Keys
, , ,
ACCEL DECEL w2t HOLD
, located to the right of the keypad. (All keys are discussed in more detail in the next
(Clear Entry) key and
ENTER/RCALL
1
SPEED
µ
TIME
TEMP
PROG SAVE
, , and along the bottom of the display area.
PROG SAVE
key.
2 3
7 8 9
VACUUM
4 5 6
1 2 3
START
0 CE
STOP
ENTER/RECALL
POWER OFF
, , and to the left
SPEED TIME TEMP
VACUUM
2
t value (when in that
PN LL-IM-12AB
,