Power On The System For The First Time - Oracle SPARC T5-4 Installation Manual

Power on the System for the First Time

Power on the System for the First Time

1.
At the terminal device, log in to the SP as root with a password of changeme.
XXXXXXXXXXXXXXXX login:
Password:
displayed)
. . .
->
After a brief delay, the Oracle ILOM prompt is displayed (->).
Note -
and its password are provided with the system. To build a secure environment, you must change
the default password (
login to Oracle ILOM. If this default Administrator account has been changed, contact your
system administrator for an Oracle ILOM user account with Administrator privileges.
For more information about the administration tasks such as changing passwords, adding
accounts, and setting account privileges, refer to the Oracle ILOM documentation.
Note -
to assign a static IP address to the SP,
Port" on page 80
2. Power on the server using one of the following methods:
Press the power button.
■
At the Oracle ILOM prompt, type:
■
-> start /System
Are you sure you want to start /System (y/n)?
The server initialization might take several minutes to complete.
To cancel the initialization, press the #. (Hash+Dot) keys to return to the Oracle ILOM prompt.
Then type: stop /System
Note -
the legacy name in a command at any time, but to expose the legacy name in the output, you
must enable it with ->
Oracle ILOM 3.1 documentation.
70 SPARC T5-4 Server Installation Guide • July 2015
root
nothing
changeme
(
To enable first-time login and access to Oracle ILOM, a default Administrator account
) for the default Administrator account (root) after your initial
changeme
By default, the SP is configured to use DHCP to obtain an IP address. If you plan
for more instructions.
In Oracle ILOM 3.1, the name space for /SYS was replaced with /System. You can use
set /SP/cli legacy_targets=enabled
see"Assign a Static IP Address to the NET MGT
y
. For more information, see the