Table of Contents
Advertisement
Installing the Shipping Brace Assembly
Related Information
"CMA Kit (CMA Comb, Part Number 7069793)" on page 43
■
"Determine Correct Rackmount Hardware" on page 36
■
Installing the Shipping Brace Assembly
This shipping brace assembly is included in the shipping kit with the CMA comb, part number
7069640. Use these procedures if you are installing the server into an equipment rack that will
be shipped to another location.
Note -
holes. If you are installing the server into a rack with round mounting holes, see
Correct Rackmount Hardware" on page
"Determine Correct Shipping Brace Fasteners" on page 50
■
"Install the Top Rear Braces " on page 50
■
"Install the Bottom Rear Shipping Brace " on page 51
■
Related Information
"Rack Compatibility " on page 30
■
"Determine Correct Rackmount Hardware" on page 36
■
"Mark the Rackmounting Location" on page 36
■
"Install the Server" on page 53
■
Shipping Brace Assembly
The shipping brace assembly provides extra shock and vibration protection. Use this kit when
installing the server into a vehicle, or when you are installing the server into an equipment rack
that will be shipped to another location for final installation.
48
SPARC T5-4 Server Installation Guide • July 2015
These procedures describe how to install the server into a rack with square mounting
36.
"Determine
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARC T5-4 and is the answer not in the manual?
Questions and answers