Table of Contents
Advertisement
3.
Set the IP address for the SP gateway.
set /SP/network pendingipgateway=gateway-IPaddr
->
Set 'pendingipgateway' to 'gateway-IPaddr'
4.
Set the netmask for the SP.
->
set /SP/network pendingipnetmask=255.255.255.0
Set 'pendingipnetmask' to '255.255.255.0'
This example uses 255.255.255.0 to set the netmask. Your network environment subnet might
require a different netmask. Use a netmask number most appropriate to your environment.
Verify that the pending parameters are set correctly.
5.
show /SP/network
->
/SP/network
Targets:
Properties:
commitpending = (Cannot show property)
dhcp_clientid = xxx.xxx.xxx.xxx
dhcp_server_ip = xxx.xxx.xxx.xxx
ipaddress = xxx.xxx.xxx.xxx
ipdiscovery = dhcp
ipgateway = xxx.xxx.xxx.xxx
ipnetmask = 255.255.255.0
macaddress = xx:xx:xx:xx:xx:xx
managementport = MGMT
outofbandmacaddress = xx:xx:xx:xx:xx:xx
pendingipaddress = service-processor-IPaddr
pendingipdiscovery = static
pendingipgateway = gateway-IPaddr
pendingipnetmask = 255.255.255.0
pendingmanagementport = MGMT
sidebandmacaddress = xx:xx:xx:xx:xx:xx
state = enabled
6.
Set the changes to the SP network parameters.
->
set /SP/network commitpending=true
Set 'commitpending' to 'true'
You can type the show /SP/network command again to verify that the parameters have
Note -
been updated.
Set the static IP address when you configure the Oracle Solaris OS.
7.
See
"Configure the Preinstalled OS" on page
Assign a Static IP Address to the NET MGT Port
72.
Powering On the Server for the First Time
81
Advertisement
Table of Contents
