Table of Contents
Advertisement
Reach a State to Install a Fresh OS (Oracle ILOM CLI)
->
set /HOST/bootmode script="setenv auto-boot? false"
This setting prevents the server from booting from the preinstalled OS. When you use
bootmode, the change applies only to a single boot and expires in 10 minutes if the power on the
host is not reset.
3.
When you are ready to initiate the OS installation, reset the host.
reset /System
->
Are you sure you want to reset /System (y/n)?
Performing reset on /System
Note -
the legacy name in command at any time, but to expose the legacy name in the output, you must
enable it with ->
ILOM 3.1 documentation.
4.
Switch communication to the server host.
start /HOST/console
->
Are you sure you want to start /HOST/console (y/n)?
Serial console started. To stop, type #.
The server might take several minutes to complete POST, and then the OpenBoot prompt (ok) is
displayed.
5.
Boot from the appropriate boot media for your installation method.
For more information, refer to the Oracle Solaris installation guide that corresponds to your
desired release and installation method.
Installing Oracle Solaris 11 Systems, comparing installation options at:
■
http://www.oracle.com/goto/Solaris11/docs
Oracle Solaris 10 Installation Guide: Planning for Installation and Upgrade, choosing an
■
Oracle Solaris installation method at:
http://www.oracle.com/goto/Solaris10/docs
For a list of valid boot commands, type:
{0} ok
boot <specifier> ( -- )
Examples:
boot
74
SPARC T5-4 Server Installation Guide • July 2015
In Oracle ILOM 3.1, the name space for /SYS was replaced with /System. You can use
set /SP/cli legacy_targets=enabled
help boot
boot kernel ( default ) or other file
- boot kernel from default device.
y
. For more information, see the Oracle
y
Factory default is to boot
from DISK if present, otherwise from NET.
Advertisement
Table of Contents
