Table of Contents
Advertisement
Reach a State to Install a Fresh OS (Oracle ILOM Web Interface)
3.
In the Oracle ILOM web interface, in the left navigation pane, choose Host
Management > Host Boot Mode.
The Host Boot Mode page is displayed.
4.
Apply these changes to the Host Boot Mode Settings:
For State, select: Reset NVRAM
a.
This setting applies a one-time NVRAM (OpenBoot) change based on the script setting,
then resets the NVRAM to default settings on the next host reset.
For Script, type:
b.
This setting configures the host to stop at the ok prompt instead of automatically booting
the preinstalled OS.
c.
Click Save.
Note -
automatically returned to normal.
In the left navigation panel, click on Host Management > Power Control.
5.
Select Reset from the pull-down menu, and click Save.
6.
7.
In the left navigation panel, click on Remote Control > Redirection.
8.
Select Use Serial Redirection, and click Launch Remote Console.
As the host resets, messages are displayed in the serial console. The reset activity takes a few
minutes to complete. When the ok prompt is displayed, continue to the next step.
9.
At the ok prompt, boot from the appropriate boot media for your installation
method.
For more information, refer to the Oracle Solaris installation guide that corresponds to your
desired release and installation method.
Installing Oracle Solaris 11 Systems, comparing installation options at:
■
http://www.oracle.com/goto/Solaris11/docs
Oracle Solaris 10 Installation Guide: Planning for Installation and Upgrade, choosing an
■
Oracle Solaris installation method at:
http://www.oracle.com/goto/Solaris10/docs
For a list of valid boot commands that you can enter at the OpenBoot prompt, type:
76
SPARC T5-4 Server Installation Guide • July 2015
setenv auto-boot? false
You have 10 minutes to perform the next step. After 10 minutes, the state is
Advertisement
Table of Contents
