Install The Cma Comb - Oracle SPARC T5-4 Installation Manual

Install the CMA Comb

Install the CMA Comb
You will be installing the single-unit CMA comb. For installation of the multi-piece CMA, see
"Install the CMA (Multi-piece CMA)" on page
The CMA is attached to the rear posts of the rack.
Note -
unavailable.
1. Confirm that you have the correct hardware to install the CMA
Correct Rackmount Hardware" on page
2. At the front of the system, remove four screws, two per side.
3. At the rear of the system, on square hole racks, remove the middle adapter
screw on each side and push the system forward 3 in. (76 mm).
Caution -
Attach the left and right CMA brackets to the comb, using three M6 screws per
4.
side.
Attach the CMA comb to the rack posts, using two M6 screws per side.
5.
At the front of the system, push the system back until it touches the rails.
6.
44 SPARC T5-4 Server Installation Guide • July 2015
The CMA installation might block some of the power outlets in the rack, making them
Do not remove the top adapter screw on the square hole racks.
46.
36).
("Determine