Calibration Screen - Extron electronics TLP Pro 1022M User Manual

Menu PIN
The PIN setup options allow you to enable, disable, or change the setup menu PIN. The PIN is a
4-digit number. Each digit can have any value from 0-9.
1.
2.
3.
4.
5.
Communication LED
The LED can be enabled or disabled.

Calibration Screen

Figure 13.
1.
2.
3.
4.
Select the first digit of the PIN. When selected, it is highlighted in yellow.
Enter New Menu PIN
1 2 3 4
1 2 3
4 5 6
7 8 9
0
Figure 12. Numeric Keypad for Setting PIN
Press a number on the keypad. That number appears in the PIN.
Repeat steps 1 and 2 for the other 3 digits.
The title bar changes to
Confirm New Menu Pin
Enter the PIN a second time. When the PIN entered on the second occasion matches the
PIN entered on the first occasion, the PIN is set and the dialog closes.
Touch crosshair to calibrate
1024x600
Calibration Screen
Press and hold down the
Menu
the rear panel (see figure 3,
Release the button. The calibration screen opens to show cross-hairs.
Follow the on-screen instructions until all five sets of cross hairs have been calibrated (one in
each corner and a fifth in the center of the screen).
The touchpanel exits the calibration screen once the calibration process is completed.
Back
Cancel
.
button for at least 3 seconds. The
C on page 5).
TLP Pro 1022 Series • On-screen Menus
button is located on
Menu
13