On-Screen Menus; Setup Menu; Status Screen - Extron electronics TLP Pro 1022M User Manual

On-screen Menus

On-screen menus allow initial configuration of the TLP Pro 1022 series:
•
•

Setup Menu

To open the setup menu, use a screw driver with a fine blade to press the
Menu
the front panel of the TLP Pro 1022M (see
The menus open at the
Display, Audio, and Advanced). These can be selected by pressing the appropriate button in
the navigation panel at the top of the screen. The button for the selected screen is yellow; the
buttons for the remaining screens are black.
There is also a red
and saves any changes and closes the menu screens.
In this section, the figures show the screens for the TLP Pro 1022M. The screens for the
TLP Pro 1022T are similar.
Status
Press the
screen.
Model:
Part Number:
Firmware
Version:
Bootloader
Version:
PoE Status:
Figure 5.
The
Each of the other four panels shows a summary of the information on the other screens.
Pressing any of the panels opens the corresponding screen in exactly the same way as pressing
the buttons in the top navigation panel.
The green bubble in the
square appears if there is no connection. The green bubble in the
control processor is connected or a red square appears if none is connected.
Setup Menu
Calibration Screen
button is located on the rear panel of both models (see
screen. There are five different screens (Status, Network,
Status
button in the top right corner of the screen. Pressing this button applies
Exit
Status button in the navigation panel at the top of the screen to open the
Display
Status
Network
Network
Info
IP Address: 192.168.254.251
TLP Pro 1022M DHCP: Off
Host Name: TLP-AB-CD-EF
60-1602-02
1.02.0001-b001
Audio
1.03.0000 Master Volume:
Master Mute:
Active

Status Screen

screen is a read-only screen that provides basic information about the touchpanel.
Status
Network
figure
figure 2, on page 4).
G
Audio Advanced Exit
Display
Resolution: 1024x600
GUI Project: N/A
Sleep Timer: 5 Minutes
Advanced
99 Controller IP: N/A
Off Project Size: N/A
panel lights when there is a network connection or a red
TLP Pro 1022 Series • On-screen Menus
Menu button. The
3, on page 5) or below
C
Status
panel lights when a
Advanced
8