Network Screen - Extron electronics TLP Pro 1022M User Manual

3.
If DHCP is disabled, set the unit IP address, subnet mask, gateway address, and DNS
server address.
a. Press the button for the address to be edited. A screen opens, showing the address
and a numerical keypad.
IP Address
1 9 2 1 6 8 2 5 4
1 2
4 5
7 8
0
Back
Figure 8. Numeric Pad for Setting IP Addresses
b.
Press to remove the old address. If you start typing without pressing
Clear
first octet is over-written and the other octets remain the same.
c. Press any octet button to highlight and start editing it.
d.
Enter the 3-digit value for that octet (leading zeroes in the octet are ignored).
NOTE: Octets can have any value between
invalid number, for example
entered.
Click Back to delete the last digit. If no value has been entered for the selected octet,
pressing moves the cursor back to the previous octet and deletes the last digit of
Back
that octet.
e. Press the next octet button and enter a value.
f. c - e until values have been entered for all four octets.
Repeat steps
g. Press to save the changes and return to the
OK
or press to return to the
Cancel
the changes.
4. If you have changed any of the values in the
button changes to blue. Press
the previous values without saving the changes. The button returns to gray.
If you have not made any changes, the
Clear
2 5 1
3
6
9
OK
Cancel
and
0
, you are able to enter the
892
Network
screen without saving
Network
screen, the background color of the
Network
to apply the new values or press
Apply
and
Apply Revert
TLP Pro 1022 Series • On-screen Menus
, the
Clear
. If you attempt to enter an
255
but the cannot be
89 2
screen
0.0.0.10
to return to
Revert
buttons are grayed out.
10