Rear Panel Features - Extron electronics TLP Pro 1022M User Manual

E
F
G

Rear Panel Features

E
A
B
C
TLP Pro 1022M
A
B
C
D
Figure 3.
A
B
C
D
Speakers (see figure 2 on the previous page) — two speakers are located below the
screen, one on each side of the panel, and provide audible feedback for the user.
Motion sensor — detects motion between three to five feet from the touchpanel, and at
least 15° from the center axis.
When no motion has been detected for a user-defined period of time, the touchpanel
•
enters sleep mode.
When motion is detected by the sensor, the screen display is restored and active.
•
Menu button — activates the
page 13). Only the TLP Pro 1022M has a
panel. The button is recessed in a hole below the front panel (see the arrow in
Use a screw driver with a fine blade to press the button.
Reset LED
Reset button
Menu button
LAN/PoE connector
TLP Pro 1022 Series Rear Panels
Reset LED— indicates power status and reset status of the device (see
page 23).
Reset button— initiates one of three reset modes for the unit (see
page 23).
Menu button— activates the
page 13).
LAN/PoE Connector— is on the back of the TLP Pro 1022M. On the TLP Pro 1022T, it is
in the top of the recessed area, to the right side.
NOTE:
These touchpanels are shipped without a power injector. The power injector
must be purchased separately.
ATTENTION:
The touchpanels are Power over Ethernet (PoE 802.3af, class 3) compliant. Do
•
not connect a power supply before reading the Attention notifications on
Les écrans tactiles sont compatible avec l'alimentation POE via Ethernet
•
(PoE 802.3af, classe 3). Ne branchez pas de sources d'alimentation externes
avant d'avoir lu les mises en garde sur
Setup Menu (see page 8) and
button that can be accessed from the front
Menu
D
TLP Pro 1022T
Mounting holes
E
Status light (TLP Pro 1022T only)
F
VESA mounting holes
G
Base attachment hinges
H
Setup Menu (see page 8) and
page 6.
TLP Pro 1022 Series • Panel Features
Calibration Screen (see
figure 2, G
(TLP Pro 1022M only)
(TLP Pro 1022T only)
(TLP Pro 1022T only)
Reset Modes on
Reset Modes on
Calibration Screen (see
page
).
F
G
C
B
A
H
6.
5