Mounting The Tlp Pro 1022T; Removing The Base And Back Covers; Kensington ® Security Lock - Extron electronics TLP Pro 1022M User Manual

Mounting the TLP Pro 1022T

The TLP Pro 1022T comes with a stand that allows it to be placed on any suitable flat surface.
See
purchased separately. Follow the installation instructions provided with the kit.

Removing the Base and Back Covers

To attach cables and to mount the TLP Pro 1022T with the
following page) or by
covers:
1.
2.
Kensington Security Lock
®
For added security, attach a Kensington Security Lock (not provided) to the metal-reinforced slot
on the rear edge of the base (see figure 20,
manufacturer to install the lock.
www.extron.com for a range of available optional mounting kits. The kits must be
VESA Mounting
Remove the base cover using the provided Extron removal tool. There is a notch at the back
edge of the cover (see figure 20,
1 1
Figure 20. Rear of TLP Pro 1022T Base
When the base cover is removed, a pull tab can be seen (see figure 21). Use this to remove
the back cover.
Figure 21.
TLP Pro 1022T with Base Cover Removed
NOTE: When replacing the covers, attach the back cover before the base cover.
SMA-1 swivel mount adapter
(see following page), you must remove the base and back
).
2
2 2
Pull Tab
(to Remove
Back Cover)
1 ). Follow the instructions that are provided by the
TLP Pro 1022 Series • Mounting
(see
21