Table of Contents
Advertisement
On-screen Menus
On-screen menus allow initial configuration of the touchpanels. The figures in this section show
screens for the TLP Pro 725T. Unless stated otherwise, the screens for the other touchpanels are
very similar.
Setup Menu
To open the setup menu, use a screw driver with a fine blade to press the
Menu button is located on the rear panel of the TLP Pro 525M, 725M, or 1025M (see
on page 8) or on the base of the TLP Pro 525T, 725T, or 1025T (see
page).
The menus open at the
•
•
•
These can be selected by pressing the appropriate button in the navigation panel at the top of
the screen. The button for the selected screen is yellow. The buttons for the remaining screens
are black.
There is also a red
and saves any changes and closes the menu screens.
Status
Press the
screen.
Model:
Part Number:
Firmware
Version:
Bootloader
Version:
Figure 6.
The
Each of the other four panels shows a summary of the information on the other screens.
Pressing any of the panels opens the corresponding screen in exactly the same way as pressing
the buttons in the top navigation panel.
A green bubble in the
appears if there is no connection. The green bubble in the
processor is connected or a red square appears if none is connected.
Status
screen. There are five different screens:
Status
(see below)
Network
(see following page)
Display
(see page 17)
Exit
button in the top right corner of the screen. Pressing this button applies
button in the navigation panel at the top of any screen to open the
Status
Display
Status
Network
Info
Network
IP Address:
192.168.254.251
TLP Pro 725T
DHCP:
Off
Host Name:
TLP-AB-CD-EF
60-1562-02
1.00.0001-b003
Audio
Master Volume:
1.00.0000
Master Mute:
Status Screen
screen is a read-only screen that provides basic information about the touchpanel.
Status
Network
panel lights when there is a network connection or a red square
TLP Pro 525, 725, and 1025 Series Touchpanels • On-screen Menus
Audio
(see page 18)
•
Advanced
(see page 19)
•
Audio
Advanced
Exit
Display
Resolution:
1024x600
GUI Project:
N/A
Sleep Timer:
5 Minutes
Advanced
99
Controller IP:
N/A
Off
Project Size:
N/A
Advanced
button. The
Menu
figure 3
figure 5
on the previous
Status
panel lights when a control
14
Advertisement
Table of Contents
Need help?
Do you have a question about the TouchLink Pro and is the answer not in the manual?
Questions and answers