Status Screen; Network Screen - Extron electronics TouchLink TLP Pro 1220 Series User Manual

Status Screen

Status
Info
Model:
Part Number:
Firmware
Version:
Bootloader
Version:
PoE Status:
Figure 6.
The
Status
touchpanel. Each of the other five panels shows a summary of the information on the other
screens. No values can be changed from this screen but pressing any of those five panels opens
the corresponding screen in exactly the same way as pressing the buttons in the top navigation
bar.
The green bubble shown in the
red square shown in the

Network Screen

The Network
addresses for the touchpanel. Verify with your network administrator whether the IP address for
the touchpanel is assigned by DHCP or set manually. If it is set manually, you need to obtain an
IP address, a subnet mask, a gateway address, and a Domain Name Server (DNS) IP address
from the network administrator.
Status
Host Name:
IP Address:
Subnet Mask:
Gateway:
Figure 7.
1. If network settings are assigned by DHCP, press
yellow. If DHCP is selected, you can only set the
DHCP server.
If IP addresses are assigned manually, press
Host Name
Audio
Network Display
Network
IP Address: 192.168.254.251
TLP Pro 1220MG
DHCP: Off
Host Name: TLP-AB-CD-EF
60-1340-02
1.02.0001-b001
Audio
1.03.0000 Master Volume: 100
Master Mute: Off
Active
Advanced
Controller IP: 192.168.254.250
Project Size: 1/196 MB
Status Screen
screen is read-only. The
Info
Network
panel indicates that no control processor is connected.
Advanced
screen allows you to set the
Network Display Audio
DHCP
On
TLP-AB-CD-EF DNS Primary:
192.168.254.251 Domain Name:
255.255.255.0 Mac Address:
0.0.0.0
Network Screen
can be edited.
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Setup Menu
Input Advanced Exit
Display
Resolution: 1280x800
GUI Project: 1280x800
Sleep Timer: 5 Minutes
Input
HDMI Port: No Signal
XTP: 1280x720
HDCP
panel provides basic information about the
panel indicates that there is a network connection. The
DHCP status and, if DHCP is set to
Input Advanced Exit
Off
127.0.0.1
00-05-A6-AB-CD-EF
Revert Apply
. The selected button is highlighted in
On
. All other values are set by the
Host Name
. When DHCP is off, all values except the
Off
Off , the network
14